ABB RDNA-01 Manual do Utilizador descarregar pdf (Página 71)

ACS550-01/U1 User’s Manual 71

Control panels

Copy mode

The Basic Control Panel can store a full set of drive parameters and up to two user

sets of drive parameters to the control panel. The control panel memory is non-

volatile.

In the Copy mode, you can:

• copy all parameters from the drive to the control panel (uL – Upload). This

includes all defined user sets of parameters and internal (not adjustable by the

user) parameters such as those created by the ID Run.

• restore the full parameter set from the control panel to the drive (dL A – Download

All). This writes all parameters, including the internal non-user-adjustable motor

parameters, to the drive. It does not include the user sets of parameters.

Note: Only use this function to restore a drive, or to transfer parameters to

systems that are identical to the original system.

• copy a partial parameter set from the control panel to a drive (dL P – Download

Partial). The partial set does not include user sets, internal motor parameters,

parameters 9905…9909, 1605, 1607, 5201, nor any Group 51: EXT COMM

MODULE and Group 53: EFB PROTOCOL parameters.

The source and target drives and their motor sizes do not need to be the same.

• copy USER S1 parameters from the control panel to the drive (dL u1 – Download

User Set 1). A user set includes Group 99: START-UP DATA parameters and the

internal motor parameters.

The function is only shown on the menu when User Set 1 has been first saved

using parameter 9902

APPLIC MACRO (see section User parameter sets on page

83) and then uploaded to panel.

• copy USER S2 parameters from the control panel to the drive (dL u2 – Download

User Set 2). As dL u1 – Download User Set 1 above.

• start, stop, change the direction and switch between local and remote control.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 319 320

Sem comentários

ABB RDNA-01 Manual do Utilizador Página 71